An Investigation of Damages in Low Power Wind Turbine Blades
Ataya, S., Ahmed, M., Ahmed, E. (2018). An Investigation of Damages in Low Power Wind Turbine Blades. EKB Journal Management System, 20(1), 80-88. doi: 10.21608/jpme.2018.39125
Sabbah Ataya; Mohamed M. Z. Ahmed; Essam Ahmed. "An Investigation of Damages in Low Power Wind Turbine Blades". EKB Journal Management System, 20, 1, 2018, 80-88. doi: 10.21608/jpme.2018.39125
Ataya, S., Ahmed, M., Ahmed, E. (2018). 'An Investigation of Damages in Low Power Wind Turbine Blades', EKB Journal Management System, 20(1), pp. 80-88. doi: 10.21608/jpme.2018.39125
Ataya, S., Ahmed, M., Ahmed, E. An Investigation of Damages in Low Power Wind Turbine Blades. EKB Journal Management System, 2018; 20(1): 80-88. doi: 10.21608/jpme.2018.39125

An Investigation of Damages in Low Power Wind Turbine Blades

Journal of Petroleum and Mining Engineering
Article 9, Volume 20, Issue 1 - Serial Number 130, 2018, Page 80-88  XML PDF (870.65 K)
Document Type: Original Article
DOI: 10.21608/jpme.2018.39125
View on SCiNiTO View on SCiNiTO
Authors
Sabbah Ataya email 1; Mohamed M. Z. Ahmed2; Essam Ahmed3
1Department of Metallurgy and Materials Eng., Faculty of Petroleum and Mining Eng., Suez University, Suez, Egypt. Department of Mechanical Engineering, College of Engineering, Al Imam Mohammad Ibn Saud Islamic University, Riyadh 11432, Saudi Arabia
2Department of Metallurgy and Materials Eng., Faculty of Petroleum and Mining Eng., Suez University, Suez, Egypt. The British University in Egypt
3Department of Metallurgy and Materials Eng., Faculty of Petroleum and Mining Eng., Suez University, Suez, Egypt.
Abstract
Data in the literature about the various types of damages in wind turbines which may result during manufacturing or operation is not enough. In the current work, a number of 18 blades of 300 kW and 81 blades of 100 kW power wind turbines are inspected using visual test (VT) and if needed using liquid penetrant test (PT) when needed. The location and size of discontinuities found are measured and documented. Types of discontinuities are categorized into four main ‎groups: 1) Transverse cracks and longitudinal cracks, 2) Hair line surface cracks, coating pores, surface damages, holes or ‎penetrations, 3) Edge cuts or crushing ‎and side separation, and 4) reworked areas.‎ The gathered data are analyzed to allocate the different forms of discontinuities about the blade length, to establish an indication of the rotor blades working conditions. It is found that the transverse carks are concentrated at the highly loaded and geometric change region of trailing edge. Longitudinal cracks up to 59 cm long are detected also at the region of the geometric change; i.e. in the root and the cover of the aerodynamic zone. Edge damages such as edge cuts or crushing and partial side separation are found in the sharp trailing edge. Surface and coating damages are observed on the leading edge due to erosion.  
Keywords
Fiber glass reinforced polymer; wind turbine blades, discontinuities; damages; VT inspection; NDT
Statistics
Article View: 334
PDF Download: 630