WEAR PARTICLES ANALYSIS AND RUNNING-IN OF LUBRICATED HERTZIAN CONTACTS | ||||
The International Conference on Applied Mechanics and Mechanical Engineering | ||||
Article 43, Volume 1, 1st Conference on Applied Mechanical Engineering., May 1984, Page 143-154 PDF (2.31 MB) | ||||
Document Type: Original Article | ||||
DOI: 10.21608/amme.1984.49171 | ||||
View on SCiNiTO | ||||
Author | ||||
S. E. KHALIFA | ||||
Colonel Dr. Eng., Machine Design Dept., Military Technical College, Cairo, Egypt. | ||||
Abstract | ||||
In running-in period, wear plays an important role in the service-life of machines. Wear is beneficial if it occurs smoothly and gradually. The object of this work is to assess the effectiveness of wear particles analysis in characterising the running-in period. A high performance dise machines, with two discs running edge-to-edge, under steady load and different slide-rolling ratios was used. The behaviour of this lubricated Hertzien contact has been followed by three analysing methods: - Ferrography analysis of the concentration, size and morphology of wear particles. - Spectrometry oil analysis of iron content in lubricants. - Micro-geometry analysis of tested surfaces The results are compared and analysed with respect to running-in phenomena. Results show that the running-in period has been detected well by two methods, ferregraphy analysis of wear particles and micro-geometry analysis. The spectrometry failed to detect this phenomena due to its insensitivity to large particles. | ||||
Statistics Article View: 70 PDF Download: 144 |
||||