ON MATERIALS HANDLING MACHINES Minimizing Adhesive Tractive Forces, Using GPOT | ||||
| The International Conference on Applied Mechanics and Mechanical Engineering | ||||
| Article 58, Volume 1, 1st Conference on Applied Mechanical Engineering., May 1984, Page 21-30 PDF (1.95 MB) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/amme.1984.49304 | ||||
 View on SCiNiTO | ||||
| Author | ||||
| Sabry A. El -Shakery | ||||
| Lecturer, Dept. of Prod. Eng. & Design, Faculty of Engineering & Tech., Menoufia University Shebin El-Kom, EGYPT. | ||||
| Abstract | ||||
| The ability of application of GPOT(Geometric Programming Optimization Technique) to design some members of materials handling machines with preventing the tipping over phenomenon is discussed. The application is done on FEL (Front-End-Loaders) and finds out the values of the design variables which are the nominal value of minimum machine weight and of maximum lifting load. These values are used to compute the minimum value of the adhesive tractive forces with avoiding the tipping over of the machine. The signomial GPOT is applied to construct design nomograms by which the designer of FEL can easily estimate values of the design variables and make correlation between these values and other parameter value. Then the preliminary information concern the method of determining stochastically the optimum real values of such design variables is given. | ||||
|
Statistics Article View: 68 PDF Download: 149 |
||||
