GEAR NOISE MEASURING TECHNIQUE
ABDELAZI, S., GADALLAH, N. (1986). GEAR NOISE MEASURING TECHNIQUE. EKB Journal Management System, 1(2nd Conference on Applied Mechanical Engineering.), 1-12. doi: 10.21608/amme.1986.51835
SH. ABDELAZI; N. GADALLAH. "GEAR NOISE MEASURING TECHNIQUE". EKB Journal Management System, 1, 2nd Conference on Applied Mechanical Engineering., 1986, 1-12. doi: 10.21608/amme.1986.51835
ABDELAZI, S., GADALLAH, N. (1986). 'GEAR NOISE MEASURING TECHNIQUE', EKB Journal Management System, 1(2nd Conference on Applied Mechanical Engineering.), pp. 1-12. doi: 10.21608/amme.1986.51835
ABDELAZI, S., GADALLAH, N. GEAR NOISE MEASURING TECHNIQUE. EKB Journal Management System, 1986; 1(2nd Conference on Applied Mechanical Engineering.): 1-12. doi: 10.21608/amme.1986.51835

GEAR NOISE MEASURING TECHNIQUE

The International Conference on Applied Mechanics and Mechanical Engineering
Article 21, Volume 1, 2nd Conference on Applied Mechanical Engineering., May 1986, Page 1-12  XML PDF (3.04 MB)
Document Type: Original Article
DOI: 10.21608/amme.1986.51835
View on SCiNiTO View on SCiNiTO
Authors
SH. ABDELAZI1; N. GADALLAH2
1Ph.D. Candidate, Machine Design Dept., Military Technical College, Cairo, EGYPT.
2Lecturer, Machine Design Dept., Military Technical College, Cairo, EGYPT.
Abstract
The paper presents a part of work carried out for the Degree of Ph.D. on noise of gear of circular arc tooth profile.
For this purpose an anechoic room has been built in the Military Technical College to measure the variation of noise level of gears of circular arc tooth profile running at different speeds and transmitting different loads. Overall noise levels were picked up by 1/2 inch condenser micro-phone and recorded by tape recorder. The readings were then analysed and the largest frequency component were determined.
Statistics
Article View: 84
PDF Download: 158