FORMULATION AND EVALUATION OF ACYCLOVIR MICROEMULSIONS | ||||
| Bulletin of Pharmaceutical Sciences Assiut University | ||||
| Article 4, Volume 36, Issue 1, June 2013, Page 31-47 PDF (396.75 K) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/bfsa.2013.63197 | ||||
 View on SCiNiTO | ||||
| Abstract | ||||
| Certain oils and surfactants were screened to select the most suitable ones for the preparation of microemulsions. Labrafil M 1944 CS®, Labrafil M 2125 CS® and Capryol 90® were selected as oils while Tween 80 was selected as a surfactant. Tween 80 was mixed with nbutanol (n-Bu) at different w/w ratios (Km) 1:2, 1:1, 2:1 and 3:1 as surfactant to cosurfactant (S/CoS) respectively. Pseudoternary phase diagrams were constructed using the selected oils (Labrafil M 1944 CS®, Labrafil M 2125 CS® and Capryol 90®) with the different Km ratios. Microemulsion formulations were prepared using Labrafil M 1944 CS®, Tween 80 and n-Bu with Km 2:1. The physicochemical characteristics involving viscosity, refractive index (RI), conductivity and pH were determined for these systems. In addition, the solubility of acyclovir in the prepared microemulsion systems (MEs) was measured. Acyclovir was incorporated to three MEs (ME10, ME50 and ME80) representing three different regions in the phase diagram; water in oil (w/o), bicontinuous (Bc) and oil in water (o/w) respectively. All of the prepared formulations were subjected to thermodynamic stability studies. The droplets size, polydispersity index (PDI) and zetapotential (ZP) of both before and after drug incorporation were determined. Acyclovir release from drug loaded MEs was determined and the kinetic of the release data was calculated. The conductivity and viscosity results proved the presence of three regions in the phase diagram (w/o, Bc and o/w). The refractive index showed that the prepared MEs were transparent and isotropic. All the formulations were thermodynamically stable. The droplet size of drug loaded MEs was higher than that of corresponding unloaded ones but all have droplet size in nano range. PDI was found to be less than 0.5 and ZP in the range of -0.101 to 2.5 mV. Release of acyclovir from ME80 (0.1, 1.99, 17.98 and 79.92 w/w for acyclovir, oil, S/CoS and water respectively) was the highest among the other ones. Model of non-Fickian "anomalous" transport release was the mechanism of drug release from the selected MEs. In conclusion, stable isotropic microemulsion systems using Labrafil M 1944 CS®, Tween 80 and n-butanol as oil, surfactant and cosurfactant respectively with Km 2:1 could be formulated. The viscosity and electric conductivity results proved the presence of three areas; w/o, Bc and o/w in phase diagram. Acyclovir could be loaded into different microemulsion systems. The percent drug release increased by increasing the water content of microemulsion. | ||||
|
Statistics Article View: 146 PDF Download: 303 |
||||
