Mushroom-like Electromagnetic Band Gap based Polarization Converters for Millimeter Wave Applications | ||||
| Menoufia Journal of Electronic Engineering Research | ||||
| Article 4, Volume 26, Issue 1, January 2017, Page 53-66 | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/mjeer.2017.63416 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
| Ahmad A. Hassan1; A. S. Elkorany1; Demyana A. Saleeb2 | ||||
| 1Faculty of Electronic Engineering, Menoufia University, Egypt | ||||
| 2Faculty of Engineering, Kafr ElShiekh University Egypt rsity. | ||||
| Abstract | ||||
| Developments in radar navigation and remote sensing required rugged and inexpensive location markers and calibration targets with very large radar cross sections and a specified polarization response. Passive radar targets derived from corner reflectors were considered for this application. These targets require polarization converters for their operation. Conventional converters suffer from heavy weight, complicated structure, losses, and/or limited bandwidth. Polarization converters made of electromagnetic band gap materials are low profile, light weight, efficient, and have large bandwidth. The work presented here is a development of a simple procedure for the design of these converters. The requirements for polarization transformation are derived. The design procedure is outlined. Mushroom-like electromagnetic band gap materials using square patches are used. These materials are made polarization dependent through making single slot or two slots in the square patches. Detailed parametric study was conducted to see the effect of different parameters upon reflection phase difference. Polarization converters to transform linear polarization to linear polarization with the reflected electric field perpendicular to the incident electric field were designed. | ||||
| References | ||||
|
troke-width: 0px; "> [1] D. G. Michelson, “Radar Cross Section Enhancement for Radar Navigation and Remote Sensing,” PhD Thesis,TheFaculty of Graduate Studies, Department of Electrical Engineering, The University of British Columbia, Dec. 1993. [2] P. J. Ferrer, and C. L. Martinez, “ Transpolarizing Trihedral Corner Reflectors Characterization Using a GB-SAR System”, Geoscience and Remote Sensing Letters, IEEE, Vol. 8, Issue 4, March 2011. [3] K. Sarabandi, “A Waveguide Polarization Controller,” IEEE Trans. Microwave Theory & Tech., Vol. 42, No. 11, Nov. 1994. [4] P. W. Gaiser, and W. L. Jones, “The WindSat Space Borne Microwave Radiometer : Sensor Description and Early Orbit Performance,” IEEE Trans. Geoscience and Remote Sensing, Vol. 42, No. 11, Nov. 2004. [5] K. Sarabandi, “A Waveguide Polarization Controller,” IEEE Trans. Microwave Theory & Tech., Vol. 42, No. 11, Nov. 1994. [6] S. Ullah, J. A. Flint, and R. D. Seager, "Polarization Dependent Electromagnetic Band Gap Incorporating a Standard Sheet Via", IET Microwave, Antennas & Propagation, 2011, 5 (5), 519. [7] F. Yang, and Y. R. Samii, "Electromagnetic Band Gap Structures in Antenna Engineering", Cambridge University Press, 2009. ; "> [8] Olli Luukkonen, “ Artificial Impedance Surfaces”, PhD thesis, Faculty of Electronics and Communications, University of Helsinky, Finland, 2009. [9] C. A. Balanis, " Antenna Theory Analysis and Design ", John Wiley &Sons Inc.,1997, P69. ------------------------------------------------------------------- | ||||
|
Statistics Article View: 107 |
||||
