Experimental Study of the Surface Roughness and the Delamination in the Drilling of GFRP and AL/SiCp Composites with Different End Mills | ||||
| ERJ. Engineering Research Journal | ||||
| Article 5, Volume 42, Issue 4, October 2019, Page 279-291 PDF (879.17 K) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/erjm.2019.66252 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
| Ahmed M. Easa1; Abeer S. Eisa2 | ||||
| 1Professor, Production engineering & Mech. Design Dept., Faculty of Engineering, Menoufiya University | ||||
| 2Lecture, Production engineering & Mech. Design Dept., Faculty of Engineering, Menoufiya University, Egypt | ||||
| Abstract | ||||
| In this research, the influence of the drilling process parameters; three cutters (end mill) of different diameters, three of cutting speeds and five of feed rates on the process responses, i.e. the surface roughness ( ) and the delamination factor ( ) of the drilled hole are studied. The two types of the used composites are GFRP and AL/SiCp. From the analysis of the results, the feed rate and the cutter diameter are had a large effect on surface roughness and delamination factor, while both of them are increased with the increase of cutter diameter and the used feed rates. The results of surface roughness and the delamination factor when drilling GFRP composite are bigger than that values of AL/SiCp composite at all used cutters, cutting speeds and all used feed rates. Also, from the results, using of cutting speed (2500 rpm), end mill of the small diameter ϕ 8mm and low feed rate (10mm/min) are suitable for drilling GFRP and AL/SiCp to get a better surface roughness of the resulted. | ||||
| Keywords | ||||
| Metal - matrix composites; GFRP; Defects; Surface Quality; Surface Delamination; milling; Machining processes | ||||
|
Statistics Article View: 181 PDF Download: 258 |
||||
