EFFECT OF COMPOSITE PREHEATING AND PLACEMENT TECHNIQUES ON MARGINAL INTEGRITY OF CLASS V RESTORATIONS
Moustafa, M., Abd El-Fattah, W., Al-Abbassy, F. (2020). EFFECT OF COMPOSITE PREHEATING AND PLACEMENT TECHNIQUES ON MARGINAL INTEGRITY OF CLASS V RESTORATIONS. EKB Journal Management System, 45(1), 93-99. doi: 10.21608/adjalexu.2020.79947
Mohamed N. Moustafa; Wegdan M. M. Abd El-Fattah; Fayza H. Al-Abbassy. "EFFECT OF COMPOSITE PREHEATING AND PLACEMENT TECHNIQUES ON MARGINAL INTEGRITY OF CLASS V RESTORATIONS". EKB Journal Management System, 45, 1, 2020, 93-99. doi: 10.21608/adjalexu.2020.79947
Moustafa, M., Abd El-Fattah, W., Al-Abbassy, F. (2020). 'EFFECT OF COMPOSITE PREHEATING AND PLACEMENT TECHNIQUES ON MARGINAL INTEGRITY OF CLASS V RESTORATIONS', EKB Journal Management System, 45(1), pp. 93-99. doi: 10.21608/adjalexu.2020.79947
Moustafa, M., Abd El-Fattah, W., Al-Abbassy, F. EFFECT OF COMPOSITE PREHEATING AND PLACEMENT TECHNIQUES ON MARGINAL INTEGRITY OF CLASS V RESTORATIONS. EKB Journal Management System, 2020; 45(1): 93-99. doi: 10.21608/adjalexu.2020.79947

EFFECT OF COMPOSITE PREHEATING AND PLACEMENT TECHNIQUES ON MARGINAL INTEGRITY OF CLASS V RESTORATIONS

Alexandria Dental Journal
Article 16, Volume 45, Issue 1, April 2020, Page 93-99  XML PDF (373.7 K)
Document Type: Original Article
DOI: 10.21608/adjalexu.2020.79947
View on SCiNiTO View on SCiNiTO
Authors
Mohamed N. Moustafa email 1; Wegdan M. M. Abd El-Fattah2; Fayza H. Al-Abbassy3
1BDS, Faculty of Dentistry, Alexandria University
2Professor of Conservative Dentistry, Faculty of Dentistry, Alexandria University.
3Professor of Dental Biomaterials Department, Faculty of Dentistry, Alexandria University, Alexandria, Egypt.
Abstract
Introduction: Different placement techniques of resin-based composite (RBC) systems have been developed to improve the marginal adaptation and reduce microleakage. These techniques included preheating and vibration of resin composite materials.
Objectives: The current study aimed to investigate the effect of preheating and placement techniques on microleakage and marginal gap formation of class V composite restorations.
Materials and methods: A total of eighty sound extracted human molars were used in this study. Standard class V cavities were prepared on their buccal surfaces (4mm mesiodistally, 3mm occlusocervically, and 3 mm pulpal depth). The teeth were divided into 4 groups (n=20): Group I: restored with Filtek bulk fill flowable composite, Group II: restored with Filtek bulk fill composite after it was heated to 60°C using Calset device, Group III: restored with Filtek bulk fill composite adapted with a vibrating instrument (Compothixo), Group IV: restored with Filtek Z350 XT. Specimens were light cured, thermocycled between (5 ºC and 55 ºC in water) and marginal gaps assessment was measured under a stereomicroscope and measured in micrometers. Then teeth were dyed with 0.5% basic fuchsin dye for 24 hours. The dyed specimens were sectioned in the buccolingual direction and evaluated for microleakage (dye penetration) using a stereomicroscope.
Results:For marginal gap assessment, results revealed a significant difference between the tested groups, where flowable bulk‑fill showed the lowest statistically significant marginal gaps compared to other groups at the occlusal and gingival margins (p < 0.05). For the microleakage test, the groups showed more microleakage at gingival margins compared to occlusal margins, flowable bulk- fill and preheated bulk -fill showed the lower microleakage scores among groups.
Conclusions: None of the placement techniques produced gap-free margins. Flowable bulk-fill composite and preheated composite preserved better marginal integrity and reduced microleakage.
Keywords
Dental Composite; preheating; Microleakage; Vibration; Marginal gap
References
  1. Dionysopoulos D, Papadopoulos C, Koliniotou-Koumpia E. The evaluation of various restoration techniques on internal adaptation of composites in class V cavities. Int J Biomater. 2014;148057.
  2. Ilie N, Kessler A, Durner J. Influence of various irradiation processes on the mechanical properties and polymerisation kinetics of bulk-fill resin based composites. J Dent. 2013;41:695-702.
  3. Daronch M, Rueggeberg FA, Moss L, de Goes MF. Clinically relevant issues related to preheating composites. J Esthet Restor Dent. 2006;18:340-50.
  4. Fróes-Salgado NR, Silva LM, Kawano Y, Francci C, Reis A, Loguercio AD. Composite pre-heating: Effects on marginal adaptation, degree of conversion and mechanical properties. Dent Mater. 2010;26:908-14.
  5. Daronch M, Rueggeberg FA, De Goes MF. Monomer conversion of pre-heated composite. J Dent Res. 2005;84:663-7.
  6. Christensen GJ. Advantages and challenges of bulk fill resins. Clin Rep. 2012,5:1-2.
  7. Agarwal RS, Hiremath H, Agarwal J, Garg A. Evaluation of cervical marginal and internal adaptation using newer bulk fill composites: An in vitro study. J Conserv Dent. 2015;18:56-61.
  8. Iovan G, Stoleriu S, Moldovanu A, Morogai S, Andrian S. SEM study of the interface between the cavity wall and composite resin in cavities filled using vibration. Int J Med Dent. 2011;1:254-8.
  9. Eunice C, Margarida A, João C, Filomena B, Anabela P, Pedro A, et al. 99mTc in the evaluation of microleakage of composite resin restorations with SonicFillTM. An in vitro experimental model. OJST. 2012;2:340-7
  10. Casselli DSM, Faria-E-Silva AL, Casselli H, Martins LRM. Marginal adaptation of class V composite restorations submitted to thermal and mechanical cycling. J Appl Oral Sci. 2013;21:184-9.
  11. Ahmed W, El-Badrawy W, Kulkami G, Prakki A, ElMowafy O. Gingival microleakage of class V composite restorations with fiber inserts. J Contemp Dent Pract. 2013;14:622-8.
  12. Yikilgan İ, Akgul S, Özcan S, Bala O, Ömürlü H. An in vitro evaluation of the effects of desensitizing agents on microleakage of Class V cavities. J Clin Exp Dent. 2016;8:e55-9.
  13. Alani AH, Toh CG. Detection of microleakage around dental restorations: a review. Oper Dent. 1997;22:173-85.
  14. Van Nieuwenhuysen JP. D Hoore W, Carvalho J, Qvist V. Long term evaluation of extensive restorations in permanent teeth. J Dent. 2003;31:395-405.
  15. Arslan S DS, Zorba YO, Ucar FI, et al. The effect of preheating silorane and methacrylate-based composites on microleakage of class V restorations. Eur J Gen Dent. 2012; 1: 178-182.
  16. Daronch M, Rueggeberg FA, De Goes MF, Giudici R. Polymerization kinetics of pre-heated composite. J Dent Res. 2006;85:38-43.
  17. Muñoz CA, Bond PR, Sy-Muñoz J, Tan D, Peterson J. Effect of pre-heating on depth of cure and surface hardness of light-polymerized resin composites. Am J Dent. 2008;21:215-22.
  18. El-Deeb HA, Abd El-Aziz S, Mobarak EH. Effect of preheating of low shrinking resin composite on intrapulpal temperature and microtensile bond strength to dentin. J Adv Res. 2015;6:471-8.
  19. Iovan G, Stoleriu S, Moldovanu A, Morogai S, Andrian S. Sem study of the interface between the cavity wall and composite resin in cavities filled using vibration. Int J Med Dent. 2011;1:254-8.
  20. OrBowski M, Tarczydło B, Chałas R. Evaluation of marginal integrity of four bulk-fill dental composite materials: In vitro study. Sci World J. 2015;701262.
  21. Jung JH, Park SH. Comparison of polymerization shrinkage, physical properties, and marginal adaptation of flowable and restorative bulk fill resin-based composites. Oper Dent. 2017;42:375-86.
  22. Knight JS, Fraughn R, Norrington D. Effect of temperature on the flow properties of resin composite. Gen Dent. 2006;54:14-6.
  23. Taraboanta, Stoleriu S, Iovan G, Moldovanu A, Georgescu A, Negraia MR, et al. Evaluation of Pre-heating Effects on Marginal Adaptation of Resin-based Materials. Mater Plast. 2018;55:238.
  24. Elsayad I. Cuspal movement and gap formation in premolars restored with preheated resin composite. Oper Dent. 2009;34:725-31.
  25. Ilie N, Bucuta S, Draenert M. Bulk-fill resin-based composites: an in vitro assessment of their mechanical performance. Oper Dent. 2013;38:618-25.
  26. Retief DH, Woods E, Jamison HC. Effect of cavosurface treatment on marginal leakage in class V composite resin restorations. J Prosthet Dent. 1982;47:496-501.
  27. Awliya WY, El-Sahn AM. Leakage pathway of Class V cavities restored with different flowable resin composite restorations. Oper Dent. 2008;33:31-6.
  28. Rodrigues Junior SA, Zanchi CH, Carvalho RV, Demarco FF. Flexural strength and modulus of elasticity of different types of resin-based composites. Braz Oral Res. 2007;21:16-21.
  29. Scotti N, Comba A, Gambino A, Paolino DS, Alovisi M, Pasqualini D, et al. Microleakage at enamel and dentin margins with a bulk fills flowable resin. Eur J Dent. 2014;8:1-8.
  30. Nagy IO, El‑Sayed HY, Shalaby ME. Evaluation of marginal seal of different composite restored class V cavity preparations with different cavosurface margins. Tanta Dent J. 2018;15:140.
  31. Arslan S, Demirbuga S, Ustun Y, Dincer AN, Canakci BC, Zorba YO. The effect of a new-generation flowable composite resin on microleakage in Class V composite restorations as an intermediate layer. J Conserv Dent. 2013;16:189-93.
  32. Wagner WC, Aksu MN, Neme AM, Linger JB, Pink FE, Walker S. Effect of pre-heating resin composite on restoration microleakage. Oper Dent. 2008;33:72-8.
  33. Didron PP, Chrzanowski, W, Ellakwa A. Effect of temperatures on polymerization stress and microleakage of class v composite restorations. OJCM. 2013;3:107-12.
  34. Yang JN, Raj JD, Sherlin H. Effects of preheated composite on micro leakage-an in-vitro study. J Clin Diagn Res. 2016;10:ZC36-8.
  35. Karaarslan ES, Usumez A, Ozturk B, Cebe MA. Effect of cavity preparation techniques and different preheating procedures on microleakage of class V resin restorations. Eur J Dent. 2012;6:87-94.
  36. Deb S, Di Silvio L, Mackler HE, Millar BJ. Pre-warming of dental composites. Dent Mater. 2011;27:e51-9.
  37. Bagis YH, Baltacioglu IH, Kahyaogullari S. Comparing microleakage and the layering methods of silorane‑based resin composite in wide class II MOD cavities. Oper Dent. 2009;34:578-85.
  38. Jaganath BM, Krishnegowda SC, Rudranaik S, Madanan S, Kurup NB, Manjula CG. Influence of composite insertion techniques (bulk fill and incremental nanofilled technique) on adaptability to the pulpal floor and interfacial gap formation. Int J Prev Clin Dent Res. 2017;4:1-7.
  39. Habib ANA, Waly GH. The degree of conversion and class II cavity microleakage of different bulk fill composites placed with different restorative techniques. FDJ. 2018;4:231-8.
  40. Lempel E, Czibulya Z, Kovács B, Szalma J, Tóth Á, Kunsági-Máté S, et al. Degree of conversion and BisGMA, TEGDMA, UDMA elution from flowable bulk fill composites. Int J Mol Sci. 2016;17:pii: E732.
Statistics
Article View: 674
PDF Download: 1,423