Design and Implementation of CubeSat Communication System | ||||
| The International Undergraduate Research Conference | ||||
| Article 27, Volume 2, Second International Undergraduate Research Conference, IUGRC, 2017, Page 106-106 PDF (541.83 K) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/iugrc.2017.90645 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
| Amr Ahmed1; Mohammed Ateya1; Mohammed Abubakr1; Ibrahim F. Tarrad2; Mohammed Abdelmoneam3; Ahmed Farrag4 | ||||
| 1Electronics and Communication Department, High Institute for Engineering and Technology, AL-Obour, Egypt. | ||||
| 2Associated Professor, Electronics and Communication Department, Faculty of Engineering, Al-Azhar University, Egypt. | ||||
| 3demonstrator, Electronics and Communication Department, High Institute for Engineering and Technology, AL-Obour, Egypt. | ||||
| 4Engineer, Communication at NARSS, Egypt. | ||||
| Abstract | ||||
| This project aims to provide a link to relay data findings and send commands to and from the CubeSat. Telemetry and command subsystems will ensure continuous communication between the ground station and the CubeSat The CubeSat communication system is composed primarily of the telemetry and command systems, which send and receive data, respectively. Analog and digital data collected by the sensors and payload of the satellite must be relayed to the ground station via the telemetry system, which is composed of a transmitter that acts much like a “modem in a computer”. A simulation analysis are carried out for the analysis by Arduino Mega 2560 and C + program . The analysis carried for received data from ground station or cubesat Also analysis carried out for check the data by Cyclic redundancy The results show that the data is extremely verification. | ||||
|
Statistics Article View: 116 PDF Download: 53 |
||||
