POSSIBILITY OF USING CORN STALKS AS A SOURCE OF ENERGY | ||||
| Misr Journal of Agricultural Engineering | ||||
| Article 19, Volume 34, Issue 4, October 2017, Page 1837-1856 PDF (932.36 K) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/mjae.2017.96193 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
| I. S El-Soaly1; R. R. EL-Bessoumy2; A. E. M. Fodah3 | ||||
| 1Prof. of Ag. Eng., Fac. of Ag. Eng., Al-Azhar Univ., Cairo, Egypt. | ||||
| 2Assoc. Prof. of Ag. Structures and Environ. Control Dept., Fac. of Ag. Eng., Al-Azhar Univ., Cairo, Egypt. | ||||
| 3Demons. of Ag. Structures and Environ. Control Dept., Fac. of Ag. Eng., Al-Azhar Univ., Cairo, Egypt. | ||||
| Abstract | ||||
| The main objective of the present study is to develop the fundamentals of a technology for energetic utilization of corn stalks aimed to solve the problem of dangerous storing and burning of corn stalks in Egypt and to evaluate some physical properties of corn stalks briquettes, easily storable, and environmentally sound biofuel for rural areas in Egypt. Chopped corn stalks was densified into briquettes using a laboratory model vertical hydraulic press at different formation pressures of (15, 32, 49 and 60 MPa), three temperatures (room temperature (35oC), 75 and 100oC), three levels of moisture content (7.33, 8.72 and 10.52% wb) and different holding time (10, 20 and 30 min). The results showed that the highest bulk density, compression ratio, durability and water resistance were 1472 kg/m3, 27, 98% and 88 min, respectively, at formation pressure of 60 MPa, temperature of 100oC, moisture content of 7.33% and holding time of 30 min. While, the minimum resiliency obtained was 4.88%. The CO and CO2 emissions for briquettes were less than these for chopped corn stalks. | ||||
| References | ||||
|
ASAE Standard S269.4 (1996). Cubes, Pellets and Crumbles - Definition and methods for determining density, durability and moisture content.
Debdoubi A., A. Elamarti and E. Colacio (2004). Production of fuel briquettes from esparto partially pyrolyzed, Energy Conversion and Management, 46, 1877–1884.
EL-Bessoumy R. R. (2005).Effect of using agricultural residues in building materials characteristic. MSC, Thesis. Ag. Eng. Dept., Faculty of Agriculture, Al-Azhar University.
El-Khateeb, H. A.; S. K. Geneday; A. A. Soluman, M. A. El-Atter (2012). Modification of Meat Chopper Machine and Possibility of Utilization on Purpose to Briquetting of Corn Stalk. The 19th. Annual Conference of the Misr Soc. of Ag. Eng., 14-15 November, 2012: 473-492.
El Saeidy E. (2004). Technological fundamentals of briquetting cotton stalks as a biofuel (Doctoral dissertation, Humboldt-Universität zu Berlin, Land wirtschaftlich - Gärtnerische Fakultät), Renewable Energy in Agriculture in Egypt, pp: 20-34.
Fapetu, O. P. (2000). Production of charcoal from tropical biomass for industrial and metallurgical process. Nigeria Journal of Engineering Management, 1(2), 34-37.
Gamea, G. R.; E. A. El Saeidy; and S. F. El Sisi (2012). Quality properties for cotton stalks and rice straw briquettes. The 19th. Annual Conference of the Misr Soc. of Ag. Eng., 14-15 November, 2012: 303-324.
Jekayinfa S. O. and O. S. Omisakin (2005). The energy potentials of some agricultural wastes as local fuel materials in Nigeria. Agricultural Engineering International the CIGR E-Journal of Scientific Research and Development Vol., VII Manuscript E.E 05 003: 10Pp.
Jha S. K., A. Singh and A. Kumar (2008(. Physical characteristics of compressed cotton stalks. Biomass Engineering, 99, 205 – 210.
MALR (2013). Ministry of Agriculture and Land Reclamation, Agricultural research Centre, The weather monthly report, Egypt.
Mullen, J.; O. O. Fasina.; C. W. Wood.; and Y. Feng (2005). Storage and handling characteristics of pellets from poultry litter". Applied Engineering in Agriculture, 21, 645–51.
Nalladurai, K.; and R. V. Morey (2009). Factors affecting strength and durability of densified biomass products". Biomass and Bio-energy, 33, 337–359.
Oladeji, J. T.; and E. B. Lucas (2014). Densification and fuel characteristics of briquettes produced from corncob. Academia Arena, 3(6), 25-30.
Panwar, V.; B. Prasad.; and K. L. Wasewar (2011). Biomass Residue Briquetting and Characterization. J. Energy Eng.-ASCE 137, 108–114.
Yaman S., M. Sahan, H. Haykiri-Acma, K. Şeşen and S. Küçükbayrak (2001). Fuel briquettes from biomass–lignite blends. Fuel processing technology, 72(1), 1-8.
Wilaipon, P (2007). Physical Characteristics of Maize Cob Briquette under Moderate Die Pressure. The 2nd International Conference on Thermal Engineering and Applications. United Arab Emirates, Jan 3-6, 2006. UAE University. | ||||
|
Statistics Article View: 301 PDF Download: 932 |
||||
