PERFORMANCE OF DIRECT EVAPORATIVE COOLING SYSTEM UNDER EGYPTIAN CONDITIONS | ||||
| Misr Journal of Agricultural Engineering | ||||
| Article 21, Volume 31, Issue 4, October 2014, Page 1595-1620 PDF (1.09 MB) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/mjae.2014.98420 | ||||
 View on SCiNiTO | ||||
| Author | ||||
| El-Sayed G. Khater | ||||
| Lecturer. of Agric. Eng., Fac. of Agric., Benha Univ., Egypt. | ||||
| Abstract | ||||
| The main objective of this research is to optimize the parameters affecting the performance of the evaporative cooling system, to achieve that, a mathematical model of heat and mass balance of the evaporative cooling pads was developed to predict most important factors affecting the performance of the system.The model was able to predict the temperature, humidity ratio, wet bulb effectiveness, dew point effectiveness and temperature-humidity index of outlet air at different ambient air temperatures (25, 30, 35 and 40°C), different inlet air velocities (1.5, 3, 4.5 and 6 m s-1), ambient air humidities (0.01, 0.02, 0.03 and 0.04 kg kg-1) and different lengths of pad (0.5, 1.0, 1.5 and 2.0 m). The results showed that the outlet temperature increases with increasing ambient temperature, inlet air velocity, ambient air humidities and lengths of pad. The results also showed that the wet bulb effectiveness decreases with increasing ambient temperature, inlet air velocity, ambient air humidities and it increases with increasing lengths of pad. On the other hand, the dew point effectiveness decreases with increasing ambient temperature, inlet air velocity, ambient air humidities and it increases with increasing lengths of pad. The humidity ratio decreases with increasing ambient temperature and inlet air velocity and it increases with increasing ambient air humidities and lengths of pad. The temperature-humidity index increases with increasing ambient temperature, inlet air velocity, ambient air humidities and lengths of pad. The predicted outlet temperatures were in a reasonable agreement with those measured, where, it ranged 17.027 to 29.978 °C theoretically while it was from 19.605 to 30.748 °C experimentally. | ||||
| Keywords | ||||
| evaporative cooling; temperature; humidity ratio; wet bulb effectiveness; dew point effectiveness; temperature-humidity index | ||||
| References | ||||
|
Boxem, G., S. Boink and W. Zeiler (2007). Performance model for small scale indirect evaporative cooler. In: Proceedings of Clima 2007 WellBeing Indoors, REHVA world congress. Paper No. 1676, 10 – 14 June, 2007, Helsinki, Finland.
Caliskan, H., A. Hepbasli, I. Dincer and V. Maisotsenko (2011). Thermodynamic performance assessment of a novel air cooling cycle: Maisotsenko cycle. Int. J. Refrig., 34: 980 – 990.
Camargo, J. R. (2005). An evaporative and desiccant cooling system for air conditioning in humid climates. J. Braz. Soc. Mech. Sci. Eng. XXVII (2005): 243 - 247.
Camargo, J. R. and C. D. Ebinuma (2002). A mathematical model for direct and indirect evaporative cooling air conditioning systems. In: Proceedings of the ninth Brazilian congress of thermal engineering and sciences, CONEM.
Cengel, Y. A. (2006). Heat and Mass Transfer: A Practical Approach, McGraw-Hill Companies, Inc., Singapore.
Crum, D. R., J. W. Mitchell and W. A. Beckman (1987). Indirect evaporative cooler performance. ASHRAE Trans. 93 (1):1261 – 1275.
Cui, X., K. J. Chua, W. M. Yang, K. C. Ng, K. Thu and V. T. Nguyen (2014). Studying the performance of an improved dew-point evaporative design for cooling application. Applied Thermal Engineering, 63: 624 – 633.
DeShazer, J. A. and M. M. Beck (1988). University of Nebraska report for northeast regional Poultry Project NE-127. Agriculture Research Division, University of Nebraska, Lincoln.
Dowdy, J. A. and N. S. Karabash (1987). Experimental determination of heat and mass transfer co-efficients in rigid impregnated cellulose evaporative media. ASHRAE Trans., 93(2): 382 – 395.
El-Dessouky, H., H. Ettouney, and A. Al-Zeefari (2004). Performance analysis of two-stage evaporative coolers. Chem. Eng. J., 102 (3): 255 – 266.
El-Refaie, M. F. and S. Kaseb (2009). Speculation in the feasibility of evaporative cooling. Build. Environ. 44: 826 - 838.
Fehr, R. L., K. T. Priddy, S. G. McNeil and D. G. Overhults (1983). Limiting swine stress with evaporative cooling in the Southeast. Transaction of the ASAE, 26(2): 542 - 545.
Heidarinejad, G., M. F. Farahani and S. Delfani (2010). Investigation of a hybrid system of nocturnal radiative cooling and direct evaporative cooling. Build. Environ. 45: 1521 - 1528.
Hirst, E. (1973). Efficiency of Energy Use in the United States. Oak Ridge National Laboratory, 179: 1299 - 1304.
Hunn, B. D. and J. L. Peterson (1997). Cost-effectiveness of indirect evaporative cooling for commercial buildings in Texas. ASHRAE Trans. 103: 434 - 447.
Incropera, F. P. and D. P. DeWitt (1990). Introduction to heat transfer. 2nd (Ed.), John Wiley and Sons, Inc. New York.
Maclaine-cross I. L. and P. J. Banks (1981). A general theory of wet surface heat exchangers and its application to regenerative evaporative cooling. J. Heat Transfer, 103 (3): 579 – 585.
Magee, T. R. and T. Branshurg (1995). Measurement of thermal diffusivity of potato, malt bread and wheat flour. Journal of Food Engineering, 25(2): 223 - 232.
Naphon, P. (2005). Study on the heat transfer characteristics of an evaporative cooling tower. International Communications in Heat and Mass Transfer 32: 1066 – 1074.
Necati, O. M. (1985). Heat Transfer, McGraw-Hill Companies, Inc., Singapore, 1985.
Phillips, P. E. (2009). Using direct evaporative cooling and chilled water cooling. American Society of Heating. Refrigerating and Air Conditioning Engineers, Inc.
Riangvilaikul, B. and S. Kumar (2010). An experimental study of a novel dew point evaporative cooling system. Energy Build, 42: 637 – 644.
Riangvilaikul, B. and S. Kumar (2010). Numerical study of a novel dew point evaporative cooling system. Energy and Buildings, 42: 2241 – 2250.
Santos, J. C., G. D. T. Barros, J. M. Gurgel and F. Marcondes (2013). Energy and exergy analysis applied to the evaporative cooling process in air washers.International Journal of Refrigeration. 36 (3): 1154 – 1161.
Watt, J. R. and W. K. Brown (1997). Evaporative Air Conditioning Handbook, 3rd Ed., The Fairmont Press, Inc., Lilburn, GA.
Zhan, C., X. Zhao, S. Smith and S.B. Riffat (2011). Numerical study of a M-cycle cross-flow heat exchanger for indirect evaporative cooling. Build Environ. 46: 657 – 668.
Zhan, C., Z. Duan, X. Zhao, S. Smith, H. Jin and S. Riffat (2011). Comparative study of the performance of the M-cycle counter-flow and cross-flow heat exchangers for indirect evaporative cooling e paving the path toward sustainable cooling of buildings. Energy, 36: 6790 - 6805.
Zhao, X., J. M. Li and S. B. Riffat (2008). Numerical study of a novel counter-flow heat and mass exchanger for dew point evaporative cooling. Appl. Therm. Eng., 28 (14 – 15):1942 – 1951.
Zhao, X., Z. Duan, C. Zhan and S. B. Riffat (2009). Dynamic performance of a novel dew point air conditioning for the UK buildings. Int. J. Low Carbon Technol., 4 (1): 27 – 35. | ||||
|
Statistics Article View: 280 PDF Download: 494 |
||||
