ADJUSTED OPERATION TIME FOR POOR UNIFORMITY DRIP IRRIGATION NETWORKS | ||||
| Misr Journal of Agricultural Engineering | ||||
| Article 5, Volume 31, Issue 3, July 2014, Page 781-798 PDF (937.12 K) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/mjae.2014.98897 | ||||
 View on SCiNiTO | ||||
| Author | ||||
| M. K. El-Nemr | ||||
| Assistant professor, Department of Agricultural Engineering, Faculty of Agriculture, Damietta University. Egypt. | ||||
| Abstract | ||||
| Uniformity of water application in drip irrigation system is one of the key criteria that affects crop production and economic operation of the system. Using emitters that introduce a poor emission uniformity (EU), may turn into a must in case of lack of financial resources because of its expected low prices. A field experiment has been taken place under sandy soil conditions on squash crop. Three types of emitters G, T, and M were chosen as they had different EU levels acting excellent, good, and poor emission uniformity (EU). Network operation time was calculated basing on emitters’ mean flow rate (q\ave), average of lowest quarter flow rates (q\lq), and average of lowest half flow rates (q\lh). Crop production was significantly affected by emitter type while the base of calculating operation time did not significantly affect crop production. Crop production of emitter M increased by 25 and 35.04% by changing the operation time basing on (q\lq) and (q\lh) respectively. Energy use efficiency (EUE) for all emitters recorded its greatest values basing on (q\lq). G emitter gave the greatest value of benefits- cost ratio (B/C) compared to the facing treatments of the other two types. Emitter M recorded its greatest B/C ratio with q\lh which was also greater than all obtained B/C ratio of emitter T which had higher EU compared to emitter M. | ||||
| References | ||||
|
Alabas, M. A. (2013). Evaluation the hydraulic performance of drip Irrigation system with multi cases. Global Journal of Researches in Engineering General Engineering Volume 13(2): 12-18.
ASAE. (1994). ASAE Engineering practice. American Society of Agricultural Engineers, EP405: 724-727.
Barragan, J.; V. Bralts; and I.P. Wu (2006). Assessment of emission uniformity for micro-irrigation design. Biosystems Engineering, 93(1): 89-97.
Bhatnagar, P. R. and R.C. Srivastava. (2003). Gravity-fed drip irrigation system for hilly terraces of the northwest Himalayas. Irr. Sci., 21:151- 157.
Bressan, T (2006). Drip irrigation handbook, the Catalog for Getting Started. The Urban Farmer Store, Inc. p2.
Brouwer, C.; and M. Heibloem (1986). FAO irrigation water management training manual no. 3, part II. Determination of irrigation water needs.
Buchanan, R.J.; and T.L. Cross (2002). Irrigation Cost Analysis Hand Book. Agricultural Extension Service. The University of Tenessee. PB1721.
Culpin, C. (1976). Farm Machinery, 9th edition, Crosby Lockwood staples, London.
El-Dnasoury, M. M. (2001). Farm machinery, types and performance evaluation methods (in Arabic). Academic library, Cairo, Egypt.
El-Gindy, A.M.; A.A. Abdelaziz; and A.A. Soliman (2001). Irrigation and Drainage Networks Design, (in Arabic) Ain Shams University, Egypt.
Ella, V.B.; J. Keller; M. Reyes; and B. Yoder. (2013). A low-cost pressure regulator for improving the water distribution uniformity of a microtube-type drip irrigation system. Applied Engineering in Agriculture, 29(3):343-349
El-Nemr, M.K. (2013). Role of emission uniformity in the sustainable management of drip irrigation system. World Research Journal of Agricultural & Biosystems Engineering, Vol 2(1):17-23. FAO. (1980). Irrigation and drainage paper 36.Localized irrigation. Rome.
FAO. (1993). CLIMWAT for CROPWAT. FAO irrigation and drainage paper 49(1993).
FAO. (1998). Crop evapotranspiration - Guidelines for computing crop water requirements. FAO Irrigation and drainage paper 56.
Hazen, A.; and G.S. Williams (1920). Hydraulic Tables, 3rd ed., John Wiley and Sons, New York.
Howell, T.A. (2003). Irrigation Efficiency, in Encyclopedia of Water Science. Marcel Dekker, Inc. New York, New York. 1076 pp.
James, L.G. (1988). Principles of farm irrigation system design. John willey & sons, inc.
Karmeli, D.; and J. Keller (1975).Trickle irrigation design .Rain Bird sprinkler manufacturing crop. Glendora, California, 133.
Keller, J.; and D. Karmeli (1974). Trickle irrigation design parameters. Transaction of the ASAE, 17 (4), 678-684.
Keller, J. (2002). Evolution of drip/microirrigation: traditional and non-traditional uses. Paper presented as keynote address at the International Meeting on Advances in Drip/Micro Irrigation, December 2 to 5, 2002, Puerto de la Cruz, Tenerife, Spain.
Kepner, R.A.; R. Bainer; and E.L. Barger (1978). Principles of Farm Machinery. 3rd Ed, AVI Publishing Company Inc., Westport, Connecticut, USA.
Letey, J.; H.J. Vaux; and E. Feinerman (1984). Optimum crop water application as affected by uniformity of water infiltration. Agron. J. 76: 435-441.
Li, J.; and H.Kawano (1996). The areal distribution of soil moisture under sprinkler irrigation. Agricultural Water Management. 32: 29–36.
López-Mata, E.; J.M. Tarjuelo; J.A. de Juan; R. Ballesteros; and A. Domínguez (2010). Effect of irrigation uniformity on the profitability of crops. Agricultural Water Management, 98 (2010): 190–198.
Mantovani, E.C.; F.J. Villalobos; F. Orgaz; E. Fereres (1995). Modeling the effects of sprinkler irrigation uniformity on crop yield. Agric. Water Manage. 27: 243–257.
Mirjat, M. S.; M. U. Mirjat; and F. A. Chandio (2010). Water distribution pattern, discharge uniformity and application Efficiency of locally made emitters used in a trickle subunit. Pak. J. Agri., Agril. Engg., Vet. Sci., 2010, 26 (1): 1-15.
Sepaskhah, A.R.; and B. Ghahraman (2004). The effects of irrigation efficiency and uniformity coefficient on relative yield and profit for deficit irrigation. Biosystems Engineering 87 (4), 495-507.
Von Bernuth, R.D.; and K.H. Solomon, 1986. Design principles in Nakayama, F.S. and D.A. Bucks (1986). ELSEVIER Science Publishers.p31.
Warrick, A.W.; W.R. Gardner (1983). Crop yield as affected by spatial variations of soil and irrigation. Water Resour. Res. 19:181–186.
Wu, I. P., and H. M. Gitlin. (1973). Hydraulics and uniformity of drip irrigation. Journal of Irrigation and Drainage Division, ASCE, 99(2): 157－167. Wu, I.P. and H.M. Gitlin (1975). Energy gradient line for drip irrigation laterals. J.Irrig. and Drain. Div., Amer.Soc.Civil Eng.101(IR4):321-326. Wu, I. P.; J. Barragan, and V. Bralts (2006). Field performance and evaluation. In F. R. Lamm, J.E. Ayars; and F. S. Nakayama (Eds.), Micro-irrigation for crop production, Amsterdam. Elsevier, 357-387.
Yıldırım, G. (2007). An assessment of hydraulic design of trickle laterals considering effect of minor losses. Irrig Drain (ICID Journal) 56(4):399–421 | ||||
|
Statistics Article View: 119 PDF Download: 193 |
||||
