Effect of Machining Parameters on the Machining Characteristics of Epoxy/Tin Nanocomposites using Taguchi Design of Experiments Approach | ||||
| Engineering Research Journal (Shoubra) | ||||
| Volume 43, Issue 1, January 2020, Page 51-56 PDF (763.58 K) | ||||
| Document Type: Research articles | ||||
| DOI: 10.21608/erjsh.2020.405736 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
| Y. S.R. Matar; E. H. Mansour; S. S. Habib; T. S. Mahmoud | ||||
| Mechanical Engineering Department, Shoubra Faculty of Engineering, Benha University, Cairo, Egypt. | ||||
| Abstract | ||||
| The present work represents an experimental study of the machinability of epoxy/TiN nanocomposites during turning. The effect of the cutting speed, feed rate, depth of cut and the cooling condition on the machining characteristics, typically, the surface roughness (Ra), the material removal rate (MRR) and roundness error (Er) of the machined epoxy/TiN nanocomposites specimens were investigated. The machining experiments were designed using Taguchi approach. The results revealed that the cooling condition showed no or slight influence on the MRR, Ra and Er of epoxy/TiN nanocomposites. The other machining parameters exhibited significant influences on the MRR, Ra and Er of epoxy/TiN nanocomposites. | ||||
| Keywords | ||||
| Machinability; Nanocomposites; Design of Experiments; Taguchi; Epoxy; TiN | ||||
|
Statistics Article View: 78 PDF Download: 28 |
||||
