Experimental Investigation for Flow Boiling Heat Transfer Enhancement on R134a Using Nanorefrigerants | ||||
| Engineering Research Journal (Shoubra) | ||||
| Volume 40, Issue 1, April 2019, Page 48-56 PDF (1.63 MB) | ||||
| Document Type: Research articles | ||||
| DOI: 10.21608/erjsh.2019.406879 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
| S. A. Elsayed; H. E. Abdelrahman; A. A. Eltohamy; R. Y. Sakr | ||||
| Mechanical Engineering Department, Faculty of Engineering at Shoubra, Benha University, Cairo, Egypt. | ||||
| Abstract | ||||
| Experimental study exploring the heat transfer increase in double tube evaporator of vapor compression unit using nanorefrigerants is investigated. Aluminum oxide Al₂O₃ and copper oxide CuO nanoparticles are dispersed into refrigerants R134a, to form nanorefrigerant. Aluminum oxide nanorefrigerant void fraction is ranged from 0.1% to 0.70% whereas copper oxide nanorefrigerant void fraction is ranged from 0.06% to 0.16%. Nanorefrigerant absorbs its latent heat of evaporation from hot water flowing in the annular space of the evaporator. The effect of nanorefrigerant void fraction, heat flux, and the hot water flow rate and its temperature at the evaporator inlet on flow boiling heat transfer is illustrated. The results showed that higher values of heat transfer coefficient (h.t.c) are attained in case of using R134a. Also, a maximum value of the htc at void fraction of 0.09% CuO nanoparticle and 0.5% of Al2O3 nanoparticles for R134a is noticed. Empirical correlation equations for the htc in terms of the operating parameter are obtained. | ||||
| Keywords | ||||
| Heat Transfer; Flow Boiling; Nanofluids; Vapor Compression | ||||
|
Statistics Article View: 68 PDF Download: 35 |
||||
