DEVELOPMENT OF DYNAMIC MODEL FOR VIBRATION CONTROL OF FLEXIBLE BEAM | ||||
| JES. Journal of Engineering Sciences | ||||
| Article 4, Volume 44, No 5, September and October 2016, Page 555-565 PDF (1.08 MB) | ||||
| Document Type: Research Paper | ||||
| DOI: 10.21608/jesaun.2016.117616 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
Mark Adel  ; Khalil Ibrahim; Abdel-Rassoul Gad; Abo El-Makarem Khalil
| ||||
| Department of Mechanical Eng., Faculty of Engineering, Assiut University, Assiut, Egypt | ||||
| Abstract | ||||
| The present study aims at developing a new dynamic model for vibration control of a composite carbon cantilever beam. The finite element method (FEM) is used to derive the introduced model. Modal analysis is performed on the cantilever beam using ANSYS software package and results were compared with similar published work using ABAQUS software package to validate the results obtained from ANSYS. The theory behind the extraction of flexible beam model from the finite element model is introduced. The eigenvalues and eigenvectors resulting from this analysis are integrated into MATLAB, which is used to derive the state space model of the system. Through MATLAB/ SIMULINK tools a PID controller was designed and controlled system performance under different system inputs is studied to test the efficiency of the controller. The results show similar responses and similar error percentage signals to various step input angles. In addition, the system shows a good performance to sine wave input signal despite the presence of a minor lag. | ||||
| Keywords | ||||
| Dynamic model; Finite Element; Modal Analysis; ANSYS; MATLAB | ||||
|
Statistics Article View: 135 PDF Download: 1,197 |
||||
