An Experimental Evaluation of a Developed Flame Holder Supplied with Two Air Sources | ||||
| Engineering Research Journal (Shoubra) | ||||
| Volume 51, Issue 4, October 2022, Page 53-60 PDF (1.01 MB) | ||||
| Document Type: Research articles | ||||
| DOI: 10.21608/erjsh.2022.258723 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
Islam M. Mesallam  1; Ahmed Attia Abd El Latief Attia Attia2; Khairy H. El-Nagar1; ,Ismail M.M. ElSemary1
| ||||
| 1Combustion and Energy Technology Lab, Mechanical Engineering Department, Shoubra Faculty of Engineering, | ||||
| 2professore of menchanical engineering power shoubra faculty of engineering Benha univ | ||||
| Abstract | ||||
| : In this study, a new developed flame holder which is designed as a double cone with three holes at the top cone to spout the fuel to the combustion zone has been investigated experimentally. The air and fuel have been supplied to the combustion area through a triple coaxial pipe.The inner pipe of the coaxial pipe delivers fuel, while the middle and outside pipes deliver primary and secondary air to the combustion zone, respectively. A conversion diversion channel is constructed on the primary air output to optimize air and fuel mixing by increasing turbulence in the primary air. The experiment was carried out in still air under atmospheric circumstances, using the diffusion flame concept.The results showed that mixing secondary and primary air in the combustion zone had an effect on flame temperatures, flame length, flame width, and emissions. | ||||
| Keywords | ||||
| diffusion jet flame; Flame holder; Flame length; flame width; emissions | ||||
|
Statistics Article View: 117 PDF Download: 84 |
||||
