Investigation On the Effect of Variation of Drilling Parameters On the Delamination Factor in Waste Tire Rubber Polyester Composite Laminates | ||||
| Benha Journal of Applied Sciences | ||||
| Article 32, Volume 7, Issue 4, April 2022, Page 249-252 PDF (724.78 K) | ||||
| Document Type: Original Research Papers | ||||
| DOI: 10.21608/bjas.2022.260500 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
| M. Mosaad; T. S.Mahmoud; Bassant Hany Mousa; Ibrahim Mousa; S. S. Mohamed | ||||
| Mechanical Engineering Dept, Shoubra Faculty of Engineering, Benha Univ., Benha, Egypt | ||||
| Abstract | ||||
| The waste tire rubber particles are as a filler for a laminated polyester composite with glass fiber, resulting in improved mechanical and physical properties. This innovative material has a wide range of uses, including automotive pumpers and the aerospace sector. The influence of drilling factors such as different twist drill sizes and varying feed rates on the delamination factor is studied in this paper. Comparison between different twist drill sizes shows that the minimum size leads to minimum delamination factor, and the lowest feed rate leads to minimum delamination factor by using optimum speed in all cases. | ||||
| Keywords | ||||
| Polyester; Waste tire rubber; Fiber-Reinforcement Composite; Mechanical and physical qualities; Twist drill sizes; Feed Rate | ||||
|
Statistics Article View: 75 PDF Download: 184 |
||||
