EXPERIMENTAL BEHAVIOR OF UNREINFORCED MASONRY VAULTS STRENGTHENED USING DIFFERENT TECHNIQUES | ||||
The International Conference on Civil and Architecture Engineering | ||||
Article 9, Volume 10, 10th International Conference on Civil and Architecture Engineering, May 2014, Page 1-11 PDF (447.77 K) | ||||
Document Type: Original Article | ||||
DOI: 10.21608/iccae.2014.44088 | ||||
![]() | ||||
Authors | ||||
Osama A. Kamal1; Osama. R. El- Hariri1; Gehan A. Hamdy2; Tarik S. El-Salakawy3 | ||||
1Professor, Civil Engineering Department, Faculty of Engineering at Shoubra, Benha University. | ||||
2Associate Professor, Civil Engineering Department, Faculty of Engineering at Shoubra, Benha University. | ||||
3Ph.D. Candidate., Civil Engineering Department, Faculty of Engineering at Shoubra, Benha University. | ||||
Abstract | ||||
ABSTRACT Unreinforced masonry is the construction system of most of historic structures and a considerable percentage of existing residential buildings in Egypt. One of the important disadvantages of unreinforced masonry construction is its low resistance to tensile stresses and lateral loads, so there is frequently need for appropriate strengthening for such structures. Fiber reinforced polymer (FRP) composites have been successfully applied as externally bonded reinforcement for strengthening of reinforced concrete and masonry structural elements as well. Their excellent strength-to-weight ratio and easy installation make them an attractive alternative for traditional strengthening methods. This paper presents experimental investigation of strengthening masonry walls and vaults using FRP composites, as well as other traditional methods such as steel reinforcement bars, ferro-cement layers and polymer mortar layers. The experimental program is explained and the maximum capacity and failure mode associated with each strengthening technique are presented and compared. The experimental results showed that FRP gave higher strengthening level and better failure mode than using traditional steel reinforcement bars or ferro-cement layers. Use of glass fiber composites make it also as cheap as other techniques. Using polymer mortar was the least effective technique. Also, strengthening of masonry wall specimens using confining FRP layer was found to be a very efficient method, where the failure load was double that of the unstrengthened specimens. | ||||
Keywords | ||||
strengthening; FRP; Steel reinforcement; Ferro-cement; Unreinforced masonry; Masonry Walls; Vaults | ||||
Statistics Article View: 90 PDF Download: 100 |
||||