THE PRODUCTION OF HOLLOW ARTICLES FROM TUBES BY CONSTRAINED UPSETTING TECHNIQUE | ||||
The International Conference on Applied Mechanics and Mechanical Engineering | ||||
Article 35, Volume 2, 1st Conference on Applied Mechanical Engineering., May 1984, Page 179-187 PDF (2.21 MB) | ||||
Document Type: Original Article | ||||
DOI: 10.21608/amme.1984.49862 | ||||
View on SCiNiTO | ||||
Authors | ||||
O. I. AHMED1; O. ABDEL-AZIM2; M. ABDEL-RAHMAN3 | ||||
1Associate Professor, Dept. of Mechanical Engineering, Assiut University, Assiut, Egypt. | ||||
2Associate Professor, Dept. of Mechanical Engineering, Minia University, Minia, Egypt. | ||||
3Graduate Student, Dept. of Mechanical Engineering, Minia University, Minia, Egypt. | ||||
Abstract | ||||
An investigation is made of the radial upsetting of metallic circular tubes into a die cavity, of different contours, in which an axial collar is produced. A clew to the metal flow mode is given, the physical plane model of deformation is suggested and the corresponding triangular velocity field is constructed. An upper bound solution is utilized for finding the upsetting load. The theoretical predicted load values are compared with those obtained experimentally. Pressure rating tests of the produced articles are performed. Distribution of wall thickness strain and hardness values are determined and discussed. | ||||
Statistics Article View: 66 PDF Download: 150 |
||||