INFLUENCE OF SOLAR RADIATION AND MODULE TEMPERATURE ON SOLAR MODULE PERFORMANCE | ||||
| Misr Journal of Agricultural Engineering | ||||
| Article 2, Volume 33, Issue 3, July 2016, Page 789-804 PDF (1.2 MB) | ||||
| Document Type: Original Article | ||||
| DOI: 10.21608/mjae.2016.97724 | ||||
 View on SCiNiTO | ||||
| Authors | ||||
| Israa F. Eldehn1; M.M. Mustafa2; M. Elnono2; A. Hegazi3 | ||||
| 1Agriculture Specialist at Nuclear Res. Center, Atomic Energy Authority, Egypt. | ||||
| 2Prof. of Ag. Eng. Dept., Fac. Ag., A. Shams Univ., Egypt. | ||||
| 3Lecture of soil & water Res. Dept., Nuclear Res. Center, Atomic Energy Auth., Egypt. | ||||
| Abstract | ||||
| Photovoltaic module (PV) performance decreases with the increase of module temperature. While, it increases with increasing solar radiation intensity. PV system is used to convert solar energy into electric power then it will be connected with a pumping system (DC motor and centrifugal pump) to run trickle irrigation system for small scale areas in Inshas. Solar panels temperature and solar radiation intensity play a big part in the photovoltaic conversion process. Since solar cells are semi-conductors, they are very sensitive to temperature. The characteristic power curve is affected significantly by the module temperature. In this paper each of voltage, module efficiency and the output power of PV module depend on solar panels temperature at different values (30º- 40º- 50ºC), solar radiation intensity ranged at (900-1000)W/m2 and PV module (Polycrystalline 240 WP). During the operation of the PV, module efficiency reached to be around 14.5% which is PV conversion efficient for solar radiation to electricity. The electrical efficiency will decrease with the increase of solar panels temperature of the PV module. | ||||
| Keywords | ||||
| Photovoltaic; Solar radiation; Module temperature | ||||
| References | ||||
|
Alonso G.M.C. and Balenzategui, J.L., (2004). Estimation of Photovoltaic Module Yearly Temperature and Performance Based on Nominal Operation Cell Temperature Calculations. Renewable Energy, 29:1997–2010.
Ebaid, M.S.Y.; Qandil, H. and Hammad, M., (2013). A Unified Approach for Designing a Photovoltaic Solar System for the Underground Water Pumping Well-34 at Disi aquifer. Energy Conversion and Management, 75:780–795.
Gouws, R. and Lukhwareni, T., (2012). Factors Influencing the Performance and Efficiency of Solar Water pumping Systems: a Review. International Journal of Physical Sciences, 7(48):6169-6180. Hamrouni, N.; Jraidi, M. and Cherif, A., (2008). Solar Radiation and Ambient Temperature Effects on the Performance of a PV Pumping System, Revue des Energies Renouvelables, 11:95–106.
Nelson, J., (2003). The Physics of Solar Cells (Properties of Semiconductor Materials). Imperial College Press, London, 13–16
Schwingshackla, C.; Petitta, M.; Wagner, J.E.; Belluardo, G.; Moser, D.; Castelli, M.; Zebisch, M. and Tetzlaff, A., (2013). Wind Effect on PV Module Temperature: Analysis of Different Techniques for an Accurate Estimation. Energy Procedia, 40:77–86.
Skoplaki, E. and Palyvos, J.A., (2009). On the Temperature Dependence of Photovoltaic Module Electrical Performance: A Review of Efficiency/Power Correlations. Solar Energy, 83:614-624. | ||||
|
Statistics Article View: 155 PDF Download: 176 |
||||
