MAXIMIZE THE OUTPUT OF PHOTOVOLTAIC CELLS USING DIFFERENT HEAT REMOVAL SYSTEMS
Abed El. Mageed, H., Nour, H., Salem, E. (2015). MAXIMIZE THE OUTPUT OF PHOTOVOLTAIC CELLS USING DIFFERENT HEAT REMOVAL SYSTEMS. EKB Journal Management System, 32(3), 1359-1374. doi: 10.21608/mjae.2015.98639
H. N. Abed El. Mageed; H. M. Nour; E. L. A. Salem. "MAXIMIZE THE OUTPUT OF PHOTOVOLTAIC CELLS USING DIFFERENT HEAT REMOVAL SYSTEMS". EKB Journal Management System, 32, 3, 2015, 1359-1374. doi: 10.21608/mjae.2015.98639
Abed El. Mageed, H., Nour, H., Salem, E. (2015). 'MAXIMIZE THE OUTPUT OF PHOTOVOLTAIC CELLS USING DIFFERENT HEAT REMOVAL SYSTEMS', EKB Journal Management System, 32(3), pp. 1359-1374. doi: 10.21608/mjae.2015.98639
Abed El. Mageed, H., Nour, H., Salem, E. MAXIMIZE THE OUTPUT OF PHOTOVOLTAIC CELLS USING DIFFERENT HEAT REMOVAL SYSTEMS. EKB Journal Management System, 2015; 32(3): 1359-1374. doi: 10.21608/mjae.2015.98639

MAXIMIZE THE OUTPUT OF PHOTOVOLTAIC CELLS USING DIFFERENT HEAT REMOVAL SYSTEMS

Misr Journal of Agricultural Engineering
Article 23, Volume 32, Issue 3, July 2015, Page 1359-1374  XML PDF (1 MB)
Document Type: Original Article
DOI: 10.21608/mjae.2015.98639
View on SCiNiTO View on SCiNiTO
Authors
H. N. Abed El. Mageed1; H. M. Nour2; E. L. A. Salem3
1Prof. of Ag. Eng., Ag. Eng. dept., Fac. of Ag., Mansoura Univ., Egypt.
2Research Head, Ag. Eng. Res. Inst., Ag. Res. Center, Dokki, Giza, Egypt.
3Assist. researcher, Ag. Eng. Res. Inst., Ag. Res. Center, Dokki, Giza, Egypt.
Abstract
Cooling photovoltaic (CPV) system helps in focusing the direct solar radiation on the photovoltaic module. It has been used for evaluating the performance of the CPV module with air and water cooling systems for power output and cell temperature. Also the effect of cooling air speed and water flow rate has been analyzed for performance evaluation of the CPV module. It has been found that the electrical output of the PV by water cooling is the most efficient than air cooling. It has been noticed that the output of the CPV mainly depends on the heat extraction rate and it helps in managing the cell temperature. And also the heat extraction rate from the CPV module mainly depends on the cooling air speed and also water flow rate.
Keywords
Photovoltaic; cooling photovoltaic system (CPV); air cooled PV; water cooled PV
References
Anderson, W. G., P. M. Dussinger, D. B. Sarraf  and S. Tamanna, 2008.  “Heat Pipe Cooling of    Concentrating  Photovoltaic Cells” Advanced cooling Technologies, Inc., Lancaster, PA 17601.

Galal, M. , Eskander, S.S. and H. M. Noor. “microcontroller - based design of pv battery charge controller ” , the 18th Annual Conference of the Misr Soc. Of Ag. Eng., 26 -27 October, 2011.

Monroe, 1998. "the Basics of Axial Flow Fans is dedicated to the memory " May 31, 1998. Hudson Products Corp., Email:hudson.products@mcdermott.com

Peng, William W. (2008), Fundamentals of Turbo machinery, Wiley, ISBN 978-0-470-12422-2 

Sahan B. Antonio N., A. Engler, P. Zacharias, 2008. Development of a Single-Stage Three-Phase PV Module Integrated Converter. the project”PV-MIPS”(ContractNo.TREN/04/FP6EN/S07.34959/ 503123 ) . Kassel, Germany.

Sanusi Y. K., G.R. Fajinmi; and E.B. Babatunde. Effects of Ambient Temperature on the Performance of a Photovoltaic Solar System in a Tropical Area. The Pacific Journal of Science and Technology, Volume 12. Number 2. November 2011.

Teleke, S, M. E. Baran, S. Bhattacharya, and A. Q. Huang. “Rule-based control of battery energy storage for dispatching intermittent renewable sources,” IEEE Transactions on Sustainable Energy, vol. 1, pp. 117– 124, 2010.

Tony K. and Laura S. “System simulation of a linear concentrating Photovoltaic system with an active cooling system”, Renewable Energy 41 (2012) 254-261.

Venkanna, B. K. (2009), Fundamentals of turbo machinery, PHI learning private limited, ISBN 978-81-203-3775-6

Statistics
Article View: 90
PDF Download: 150